MECHANICAL DATA, ORDERING DATA & PHOTOMETRIC
NON CORROSIVE LUMINAIRES
The Tinak range consists of 18W, 36W and 58W single and twin
lamps fully enclosed non corrosive luminaires.
Humid and dusty areas i.e. workshops, laboratories, loading bays,
food processing plants and all other locations where there is a
presence of corrosive vapours.
The body is made from high impact injection moulded
thermoresistant acrylic or polycarbonate. The diffuser is made of
clear injection moulded acrylic with internal prisms to improve the
light distribution. The diffuser is hinged to the body to facilitate
lamp changing. Gasket is injected into the body forming a continous
and effective seal. The white prepainted steel gear tray is retained
by quick release toggle clips, Nylon suspention straps are supplied
to retain the gear tray and facilitate the installation.
Control gear is switch start as standard. All control gears are
rated 230V or 240V 50 Hz. A three way terminal block is provided,
high temperture PVC insulated wiring is used throughout.
Cable entry is via a 20mm grommeted entry hole at one end and a
20mm knock out at the other end, alternatively cables can enter
through either of the two conduit entry points in the rear of the
luminaire body. Recessed suspention lugs are fitted to the luminaire
bodies for chain suspention. Luminaires can also be fixed directly
to the mounting surface via screws or suspended on conduit via the
reinforced 20mm conduit entries provided in the rear of the
High Frequency: on request we can provide high frequency
Designed according with the following Standards: CEI 34 - 21 and